What are the operating for rubber mixers and vulcanizers?

Rubber Mixing Machine Operating Procedures

1. First check whether the voltage indicator light is normal. The machine can be started when the voltage is between 380±20V.

2. 2. Before starting the machine, check whether there is any debris between the rollers of the large and small gears.

3. 3. Check whether the lubrication system is normal. Add lubricating oil after starting the machine, and add oil every 4 hours.

4. 4. Check the cold water circulation system to ensure the temperature of the rubber mixing machine is regulated.

5. 5. Signal your companions when starting the machine.

6. 6. Check whether the electric charging pressure is normal after starting the machine.

7. 7. Check whether the brake is normal and test the brake. Allow the roller to rotate 1-3 times.

8. 8. When adding materials after starting the machine, first expand the roller with a small piece of material, and quickly add the rubber material to prevent the rubber from popping out and injuring people.

9. 9. After starting the machine, pay attention to the temperature of the roller and bearing at any time (about 40 degrees).

10. 10. When cutting, you must concentrate and have a correct posture to prevent cuts, slips, and accidents. Attention should be paid to: (1) It is strictly forbidden to start the machine with overload. (2) It is strictly forbidden to lean on any rotating part of the rubber mixing machine. (3) It is strictly forbidden to use the brake when parking.

    
    

Safety operating procedures for vulcanization

I. After taking up the post, carefully check whether the machine, oil pressure, and temperature are normal, check the machine operation and lubrication parts, and check whether the mold is damaged.

II. Strictly operate in accordance with the requirements of the vulcanization process, strictly control the vulcanization, time, and pressure, and do not leave the post without authorization.

III. The vulcanization mold must be placed in the middle of the plate.

IV. If there is a problem with electrical equipment, find an electrician for maintenance in time, and do not handle it privately.

V. Personal soldering irons are not allowed to be used without a plug. It is strictly forbidden to connect the wires privately. Violators will be held accountable.

VI. During operation, pay attention to whether the screws of various parts of the flat vulcanizer are loose at any time, and deal with problems in time.

VII. When closing the mold, it is strictly forbidden to put your hands or head between the plates to prevent accidents.

VIII. Firefighting equipment shall not be used unless there is a fire.

IX. Fireworks are strictly prohibited in the workshop.