Locking a mold onto a rubber molding machine depends on the machine type, such as a rubber compression molding press, injection molding machine, or transfer molding machine. The basic principle is to secure the mold halves to the machine platens using the correct clamping system, then verify alignment and locking before operation.
1. Stop the rubber molding machine
Stop the machine and isolate all hazardous energy (lockout/tagout).
Ensure the platens and mold mounting surfaces are clean.
Check that the mold, lifting equipment, and mounting hardware are suitable for the mold's weight.
2. Position the mold
Use an appropriately rated hoist to position the mold on the lower platen.
Align the mold with the machine centerline, locating rings, guide pins, or specified reference points.
Keep hands clear of pinch points.
3. Secure the mold to the platens
Use the machine-approved mold clamps, T-slot bolts, mounting bolts, or dedicated fastening system.
Install the required number of clamps at the specified positions.
Tighten fasteners to the manufacturer's specified torque and sequence.
Secure the upper mold half to the moving platen if the machine design requires it.
4. Check alignment and clamping
Verify that the mold sits flat and is properly supported.
Check that all fasteners and clamps are secure.
Confirm that the mold opens and closes without interference, following the machine's setup procedure.
Test the safety interlocks and use the approved low-speed or setup mode before production.
Important safety points
Never rely on hydraulic closing pressure alone to hold a mold to the platens unless the machine is specifically designed for that mounting method.
Never adjust clamps while the machine is moving or under pressure.
Follow the machine and mold manufacturers' specifications for bolt size, clamp arrangement, tightening torque, and clamping force.
Copyright © JAPLAU All Rights Reserved Technical Support: 
https://new.cnzz.com/v1/login.php?siteid=1278629928 Sitemap
